Thanksgiving Place Cards
Four fold-once name tents: two pumpkin and two maple cards, with broad autumn badges and generous blank writing space. All four cards and badges fit one template sheet.
Materials
- 180-220 gsm ivory or white cardstock
- Scissors
- Ruler and blunt scoring tool
- Craft glue stick
- Pen; optional orange and rust coloring pencils
Finished size: Each card: 86 x 35 x 30.31 mm; four independent cards
Steps
CutValley foldMountain foldGlue area
-
Print and cut four sets
Print the template page at 100% on 180-220 gsm cardstock; check the 50 mm ruler. Cut C1-C4 and D1-D4 on solid outlines, keeping stems and leaf points. Labels remain outside. D1/D2 are pumpkins; D3/D4 are maple leaves.
-
Score and write the names
Lay each tent with its 86 mm edges horizontal. Score the dash-dot line halfway up, 35 mm from the bottom. The lower half is the front. Write a name upright in the blank area 29-83 mm from the left edge and 5-30 mm above the bottom. This leaves 54 x 25 mm clear; the fold is above the name. Do not cut the fold.
-
Attach the autumn badges
Optionally color D1/D2 orange and D3/D4 rust. Glue each badge to its matching card number, on the lower front half. Put the badge bounding box 3 mm from the left edge and 4 mm above the bottom, stem upright for pumpkins and downward for leaves. Spread a thin glue-stick coat over the back, press flat and let dry. Keep glue and decoration left of the writing area.
-
Fold and stand the four tents
With the names on the outside, mountain-fold the scored center line so the plain back falls behind the name face. Crease firmly, then open to a tent with its bottom edges 35 mm apart: both faces slope 60 degrees above the table and the inside ridge angle is 60 degrees. Place each card independently at a setting. Both straight 86 mm bottom edges must touch the level table.
-
Check the place settings
Check names face guests, badges lie flat and the tents hold their 35 mm footprint without sliding or springing open; sharpen the crease if needed. Keep dry and away from candles.
Notes
The 3D model shows each piece in its finished, idealized shape; the exploded view only spreads the pieces apart. It is not a paper-physics simulation: curved shapes are forming guides, not exact physical folding or proof of developability, and intermediate fold shapes are not supplied.
- Not yet test-built in paper by SnipFold: measurements come from the digital model, so check the fit as you go.
- Original SnipFold design. One template sheet makes four complete cards. Repeat for more guests. Black outlines save ink; optional hand coloring supplies the preview colors.
- Each 86 x 70 mm blank folds into two 86 x 35 mm faces. Each front has a blank 54 x 25 mm name area to the right of its badge. No tiny tabs or slots.
- Exact rigid-face geometry; paper thickness, bend radius and springback are not simulated. Badges sit 0.2 mm above the front as a glued layer. Preview spacing separates four independent cards.
- Use stiff cardstock on a dry level table and check the crease holds.